Paradise RA 5785 User Manual download pdf (Page 32)

32 208143 REV - Operations Manual, HPA3, Mini Compact Outdoor SSPA

3.3.2 Universal M&C Settings Window

Figure 3-10 shows the ‘Settings’ window of the Paradise Datacom Universal M&C Software.

The ‘Settings’ window contains many of the global settings that are available in the SSPA.

Power Up Settings

The Mini Compact Outdoor amplifier will power up with the “last-state” settings before the unit

was powered down. Whatever attenuation setting or mute state the amplifier was in when

powered down will be the restored settings when the amplifier is powered back on.

[1] Operation Mode: Select between stand alone (single unit) or redundancy

mode of operation.

[2] Hierarchical Address: Identifies each amplifier in a redundant system as

HPA 1 or HPA 2.

[3] Redundant Startup State: Selects whether the unit should start up as the

on-line amplifier or the standby amplifier.

[4] Mute State: Determines if the unit should start up muted (transmit disabled)

or mute clear (transmit enabled).

[5] Protocol Select: Selects between Serial, IPNET or SNMP protocols. You

will be asked to verify that you wish to change the Protocol.

Communication with the amplifier may be affected.

[6] Baud Rate Select: Sets the baud rate of the unit. The supported baud rates

include: 2400, 4800, 9600, 19200, and 38400 baud. The factory default baud

Figure 3-10: Universal M&C, Settings

IPNET

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 81 82

No comments

Paradise RA 5785 User Manual Page 32